Alpha 2000 Betriebsanleitung Seite 26

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 33
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 25
17.1 Replace the Battery in the Transmitter.
17.2 The Radio Transmitter may be faulty.
17.3 The Radio Receiver may be poorly
located. Move the receiver to another
location.
17.4 The Radio Receiver may be faulty.
17.5 NOTE:-
The performance of low-power radio
remote control equipment in areas close
to broadcasting centres, microwave
communication towers, airports, etc., is
often very restricted. In such cases it may
be necessary to install special radio
controls which operate in the 27 MHz
frequency band.
The operating range of the Remote
Radio Transmitter is very short.
SYMPTOM 17 :-
SOLUTIONS 17 :-
The Courtesy Light does not switch
"On".
The Courtesy Light does not switch
"Off" automatically, ( i.e. the light
remains "On"continuously ).
18.1 Check that the wall mounted "Push-
Button" is correctly wired and that all the
contacts are "Normally Open".
18.2 Check that the push-button switch
contacts are not wet. Moisture inside the
switch can cause a short circuit.
18.3 The Push-Button Wires may be
crossed.
SYMPTOM 18 :-
SOLUTIONS 18 :-
The operator works but is very noisy.
19.1 The Worm-screw may require lubrication.
Lubricate the shaft with the special
grease as specified. Use only the type
and grade of grease stipulated.
19.2 The Worm-screw and Aluminium
Housing may have been damaged and
will need to be repaired or replaced.
19.3 The Motor Coupling may be worn or
broken.
19.4 Test the manual operation of the door.
The door may be damaged or require
realignment or adjustment.
An unbalanced door can adversely
affect the performance of the door
operator.
19.5 Inspect the door and operator for loose
fittings and fasteners and rectify.
SYMPTOM 19 :-
SOLUTIONS 19 :-
SECTION 13
TROUBLE SHOOTING GUIDE
( Section 13 continued )
Door activates itself for no apparent
reason.
16.1 A neighbour may be using radio control
equipment which is set to the same
signal code. Change the Dip-switch
Codes of both the Transmitter and
Receiver.
16.2 The Radio Receiver may be located in a
place where the radio reception is weak
or else the signal is being screened or
interfered with, e.g. close to steel doors,
close to fluorescent lamps, close to
powerful radio, microwave or television
broadcasting equipment, etc.
16.3 The Radio Receiver may be faulty.
16.4 The Wall Push-button may be faulty.
16.5 The PC Control Board may be faulty.
SYMPTOM 16 :-
SOLUTIONS 16 :-
MAN 01 - page 25
Version 5
Seitenansicht 25
1 2 ... 21 22 23 24 25 26 27 28 29 30 31 32 33

Kommentare zu diesen Handbüchern

Keine Kommentare